[. . . ] Tiller Bumper/Guard OEM-290-256 / 290-256-081 Introduction Thank you for purchasing this Bumper/ Guard for your tiller. [. . . ] • References to “Left” and “Right” are given from the operator’s position behind the handlebars. • The engine shown in the figures may not match the engine on your tiller. A Figure 2: Loosely attach rear leg of side bumper to top of engine support bracket. B Figure 3: Remove engine mounting screws (B) from right side. CAUTION TO PREVENT PERSONAL INJURY OR DAMAGE TO ENGINE: When the four engine mounting screws are removed in Step 3, the engine will not be secured to the tiller. Observe the “CAUTION” statement above and remove the four screws (B, Figures 3 and 4), lock washers and hex nuts that secure the engine to the left and right side engine support brackets. IMPORTANT: On some units, there are more than two engine mounting holes in the left and right side engine support brackets (see Fig. If the support brackets on your unit have more than two mounting holes, then be sure to note which holes are used to mount the engine. It is critical that the same holes be used when installing the bumper/guard and engine on the support brackets. Position the two legs of the front bumper underneath the left and right side engine support brackets (see Figure 5). On the right side of the engine, align the hole in the end of the bumper leg with the holes in the rear of the engine base and the engine support bracket. [. . . ] BOX 361131, CLEVELAND, OHIO 44136-0019, 1-866-840-6483 Printed in U. S. A. [. . . ]